Cool Snare Drum EQ Advice

Cool Snare Drum EQ Advice

Snare drum EQ can be amystery to someindividuals so right hereis ...More
Snare drum EQ can be amystery to someindividuals so right hereis some tip to help youout. Less

Cool Snare Drum EQ Advice

to get instant updates about 'Cool Snare Drum EQ Advice' on your MyPage. Meet other similar minded people. Its Free!

X 

All Updates


Overview:
Snare drum EQ can be a mystery to some individuals so right here is some suggestion to help you out.
Description:

1. Snare ring generally lingers between as low as 500Hz and as high as 900Hz (begin cutting with your EQ around 650Hz to start locating the ring). Be careful as the low-end of this range is also where you'll get body to your snare sound you don't want it to be too hollow sounding or thin, so do not cut too much and do so with a narrow Q worth.

2. Snare attack. The part of the attack noise. Pulling that regularity range back will soften the attack, enhancing it can help bring it out, but be mindful due to the fact that too much of that array could make the actual snares sound extremely "plasticy" and fragile rather than the softer snares that individuals usually tend to such as (more on snares sound below).

More Support

3. Snare body / beef. It's perfectly OK to have some low-end that you 'd usually think must only be for the kick drum in your snare sound. Not "HUGE" or anything, but a little to provide some more beef to the punch of the snare drum.

4. Snare body / boomy. The 200-500Hz range is tricky. There's great deals of body and fullness there, however there's additionally the dreaded "boxy and boomy" frequencies (generally around 350Hz - 450Hz). While cutting 350 can help tighten up the snare, it can additionally result in it lose a great deal of fullness. Try slim EQs and using compression before the EQ to see if that could help get some control over the lower frequencies prior to you begin EQing in the signal chain.

5. Attack times are essential: a really rapid attack will guarantee the first stick attack is pressed, whereas a slow-moving attack will "let the stick with" and then presses the body and tone of the snare drum more. As you begin to press a snare drum you'll also subtly lose some of the low frequencies (so try that rather than cutting with an EQ to see if it helps). It you put an actually hard limiter on it, the ring of the snare will be greatly increased (wicked difficult limiter, then improve your output gain a whole lot to compensate).

Posted on: 08:07 PM - 11 Feb 13

Cool Snare Drum EQ Advice
Cool Snare Drum EQ Advice page created by Audio Tips
 Write a comment   |   Share this

  |  Cancel
All
wait Posting your question. Please wait!...


About

Snare drum EQ can be a mystery to some individuals so right here is some tip to help you out.
No messages found
Tell your friends >
about this page
 Create a new Page
for companies, colleges, celebrities or anything you like.Get updates on MyPage.
Create a new Page
 Find your friends
  Find friends on MyPage from